If the password is disabled or is not supported, then the agent returns a null string. The UPS will turn back on when utility power is restored. Setting this value to noTestDiagnostics 1 has no effect. If the contact is not in its normal state. Allowed values depend on the UPS used:
| Uploader: | Tojanris |
| Date Added: | 22 October 2011 |
| File Size: | 10.95 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 1493 |
| Price: | Free* [*Free Regsitration Required] |
When the UPS batteries are replaced, this value should be reset by the administrator.
PowerNet MIB v | Schneider Electric
This value is set to fault 2. Value ok 1 means a poewrnet runtime calibration. If a value other than a supported value is pkwernet Download IPHost Network Monitor monitors for 30 days, 50 monitors free forever to start monitoring network devices right now.
The value noRebootUps 1 will always be returned when the variable is read. If a value other than a supported value is provided in a set request, the UPS interprets it as a the next higher acceptable value.
Only units that are, and can be changed.
The value noSimulatePowerFailure 1 will powetnet be returned when the variable is read. Setting this value to noRebootUps 1 has no effect. The value of no 2 indicates adapter will assume IP configuration parameters values saved in adapter's eeprom, which was orgini The value noFlashAndBeep 1 will always be returned when the var Before using TFTP to load new code image, the image file should b Allowed values are 0 or 30 seconds.
The value noTestDiagnostics 1 will always be returned when the variable is read. During this time the UPS will produce a constant warning tone which can not be disabled. Allowed values depend on the UPS used: For these adjustable units, if a va Only traps of equal or greater severity than this value are sent to the manager.
IT Management & Network Monitoring
Getting Started Knowledge Base Help. This timer is observerd only if the value of extControlAlarm is timed 2. Setting this OID to loadAndExecuteNewAgent 3 will enable adapter to load a new agent code into the flash memory and start to execute this Allowed values are 0, 60, and seconds.
If the normal operating postion cannot be set then it is contolled via the dip switch on the Measure-UPS and is therefore read-only.
PowerNet MIB v4.2.8
Allowed values are,or seconds. Setting this value to noSimulatePowerFailure 1 has no effect.
Attempting to turn off a UPS that is not on battery will result in a badValue error. If the password is disabled or is not supported, then the agent returns a null string. This is a configuration s Setting this value to noTestDiagnostics 1 has no effect.
Allowable set values are,and Once the specified plwernet has elapsed, Allowed values are 20, and seconds. The number of entries is given by the value of mconfigNumTrapReceivers.
The UPS will turn back on when utility power is restored. The variable is set to: This number is set at the factory.
Комментариев нет:
Отправить комментарий